CFC-11 Trichlorofluoromethane

CFC-12 Dichlorodifluoromethane

AIR6) to abolish the use of CFC

CFC-115 Chloropentafluoroethane

CFC-113 1,1,2-Trichloro-1,2,2-trifluoroethane

CFC-114 1,2-Dichloro-1,1,2,2-tetrafluoroethane

The data acquisition system, including transducers, shall conform to the specifications for CFC 600, as described in Appendix 5 of this Annex.

The instrumentation response value CFC, as defined in ISO 6487:2000, shall be 180 for all transducers.

The instrumentation response value CFC, as defined in ISO 6487:2000, shall be 1000. The CAC response value, as defined in ISO 6487:2000, shall be 1000 g for the acceleration.

Whereas it is established that continued emissions of certain chlorofluorocarbons and halons at current levels are likely to cause significant damage to the ozone layer; whereas there is an international consensus that significant reductions in both production and consumption of such substances are necessary; whereas Decisions 80/372/EEC ( 3 ) and 82/795/EEC ( 4 ) provide for controls which are of limited effect and which cover only two such substances (CFC 11 and CFC 12);

The Group may apply to be designated as an International Commodity Body (ICB) under Article 7(9) of the Agreement establishing the Common Fund for Commodities (CFC), for the purpose of sponsoring, in accordance with the provisions of these Terms of Reference, projects on jute and jute products to be financed by the Fund.

i(i) Fully halogenated alkanes, e.g. CCl4, CFCl3 (CFC-11), CF2Cl2 (CFC-12), C2F3Cl3 (CFC-113), C2F4Cl2 (CFC-114)

The CAC and CFC define a data channel.

Production of chlorofluorocarbon (CFC) (7) // - // - // -

The sternum deflection response is filtered once at CFC 180.

The axial compression force shall be measured with a CFC of 600.

The deceleration shall always be lower than 120 g with CFC 600 Hz.

Use of CFC-11 in manufacture of fine synthetic polyolefin fibre sheet,

Use of CFC-113 in the manufacture of vinorelbine (pharmaceutical product),

whereas Decisions 80/372/EEC (4) and 82/795/EEC (5) provide controls which are of limited effect and which cover only two such substances (CFC 11 and CFC 12);

whereas Decisions 80/372/EEC (3) and 82/795/EEC (4) provide for controls which are of limited effect and which cover only two such substances (CFC 11 and CFC 12);

Use of prohibited or restricted materials and products (asbestos, PCB, CFC, etc.)

The axial compressive force and the bending moments are measured with a CFC of 600.

The instrumentation response value CFC, as defined in ISO 6487:2000, shall be 1000.

The chest deflection between the sternum and the spine is measured with a CFC of 180.

Use of CFC-113 in the preparation of perfluoropolyether diols with high functionality,

The resultant acceleration at the centre of gravity shall be measured with a CFC of 180.

Also the use of HCFCs in the above processes when used to replace CFC or carbon tetrachloride.

The bending moment about a lateral axis at the neck/head interface is measured with a CFC of 600.

chlorofluorocarbons (CFC), hydrochlorofluorocarbons (HCFC) or hydrofluorocarbons (HFC), hydrocarbons (HC),

The readings of the measuring devices shall be recorded through independent data channels of the following CFC:

The displacement of the tibia with respect to the femur is measured at the knee sliding joint with a CFC of 180.

The axial tensile force and the fore/aft shear force at the neck/head interface are measured with a CFC of 1 000.

The resultant triaxial acceleration referring to the centre of gravity (an) (1) shall be measured with a CFC of 600.

The different parameters are recorded through independent data channels of the following CFC (Channel Frequency Class):

Use of CFC-113 in the reduction of perfluoropolyetherpolyperoxide intermediate for production of perfluoropolyether diesters,

Whereas risks to consumers arise from the increasing use in aerosol generators of flammable substances in place of chlorofluorocarbons (CFC);

The data acquisition system, including transducers, shall conform to the specifications for CFC 600, as described in Appendix 5 to this Annex.

Use of CFC-12 in the photochemical synthesis of perfluoropolyetherpolyperoxide precursors of Z-perfluoropolyethers and difunctional derivatives,

For example, 100mcg of fluticasone propionate is approximately equivalent to 200mcg of beclomethasone dipropionate (CFC containing) or budesonide.

The acceleration (a) referring to the centre of gravity is calculated from the triaxial components of the acceleration measured with a CFC of 1 000.

The trolley deceleration is measured with data channels of frequency class (CFC) 60 corresponding to the characteristics of international Standard ISO 6487 (1980).

The characteristics of the deceleration of the trolley shall be measured, from the accelerations measured on the rigid frame of the trolley, with measurement systems with a CFC of 60.

The absolute value of the linearity error of a data channel at any frequency in the CFC, must be equal to or less than 2,5 % of the value of the CAC, over the whole measurement range.

The position of the transducers measuring the deceleration of the structure during the impact must be parallel to the longitudinal axis of the trolley according to the specifications of Appendix 5 (CFC 180).

The non-CFC propellant, Norflurane, has been shown to have no toxic effect at very high vapour concentrations, far in excess of those likely to be experienced by patients, in a wide range of animal species exposed daily for periods of two years.

However, before recording, analogical filtering at a higher level than CFC should be effected in order to use at least 50 % of the dynamic range of the recorder and to reduce the risk of high frequencies saturating the recorder or causing aliasing errors in the digitalizing process.

The response curves of phase and amplitude against frequency are determined by measuring the output signals of the data channel in terms of phase and amplitude against a known input signal, for various values of this signal varying between FL and 10 times the CFC or 3 000 Hz, whichever is lower.

To enable the simplified test described in Appendix 4 to be carried out, the deceleration curve of the structure must be determined on the basis of the value of the longitudinal accelerometers at the base of the 'B` pillar on the struck side of the vehicle with a CFC of 180 by means of data channels corresponding to the requirements set out in Appendix 5.

Fully halogenated alkanes, e.g. CCl4, CFCl3 (CFC-11), CF2Cl2 (CFC-12), C2F3Cl3 (CFC-113), C2F4Cl2 (CFC-114)