Iskalni niz je ali predolg ali pa vsebuje preveč besed.
Prevodi: en > sl
1–4/4
covered cutting
1 Končna redakcija
DRUGO
Engineering structures: bridges, culverts and other overpasses, tunnels, covered cuttings and other underpasses;
grajeni objekti: mostovi, prepusti in drugi nadhodi, predori, nadkriti useki in drugi podvozi;
2 Pravna redakcija
DRUGO
bridges, culverts and other overpasses, tunnels, covered cuttings and other underpasses;
mostovi, prepusti in drugi nadhodi, predori, nadkriti useki in drugi podvozi;
3 Pravna redakcija
DRUGO
Hot rolled plate and sheet are rolled flat products which are not covered by the definitions of wide flats or hot rolled wide strip or hot rolled narrow strip above. When supplied in square or rectangular form these products must have a width of 600 mm or more. Lengths cut form coils are hot rolled flat products obtained by cutting hot rolled wide strip. Reversing mill plates are hot rolled products which are rolled on a reversing mill or any mill other than wide strip mill.
Vroče valjana debela in tanka pločevina so valjani ploščati proizvodi, ki niso vključeni v opredelitev široke plošče, ali vroče valjani široki trakovi ali vroče valjani ozki trakovi zgoraj. Kadar so dobavljeni v oglati ali pravokotni obliki, morajo biti široki 600 mm ali več. Trakovi, rezani iz svitkov, so vroče valjani proizvodi, ki se dobijo z rezanjem vroče valjanih širokih trakov. Plošče iz reverzivnega valjalnega stroja so vroče valjani proizvodi, ki so valjani na reverzivnem valjalnem stroju ali katerem koli drugem stroju, razen na stroju za široke trakove.
4 Prevajalska redakcija
izobraževanje
CELEX: 31996L0043
The controls and inspections connected with the cutting operations referred to in, inter alia, Article 3 (1) (B) of Directive 64/433/EEC and Article 3 (1) (B) of Directive 71/118/EEC must be covered (a) either:
Kontrole in pregledi v zvezi z operacijami razreza iz - med drugim - člena 3(1)(B) Direktive 64/433/EGS in člena 3(1)(B) Direktive 71/118/EGS morajo biti plačane
Prevodi: en > sl
1–4/4
covered cutting